ARDUINO UNO'S SOFTWARE PROGRAMMING (GPSSCREEN)

The objective of this programming is to understand , investigate and recognize the input and output of pin. This is all about Arduino Uno controller.

So, as my task, I need to review this programming. Review in studying and understanding the basic examples of Arduino coding of the Arduino Uno's software programming.

As figure above, is the programming of the Arduino where can be download here ;  http://www.arduino.cc/ . The software is freeware.

From the two figures above, it is Arduino Pin Mapping. The supply for the controller is around 

7-12V DC. The board has 28 pin-outs. All the pin-out for the board we can see above.

DEMONSTRATION MODEL

Base on the objective of my project is to apply system in car alarm security. So, I need to buy the demonstration model to implement the technology that use to generate a new knowledge about how to secure the car or 'any vehicles".

As usual, the system that I applied or used in car is to programmed the Arduino micro controlled by IDE (Integrated Development Engineering) on version c++.

The demonstration model that I used is car under the model of  BMW 645Ci.

The prove of purchase of car model is below.

THE FIRST TRYING AND EARLIER RESULT

The first and earlier result that can be showed by this security alarm and GPS coordinate using Arduino is shown below.

The result of Arduino GPS and GPS data longger showed there is no signal detection at current location. This case may be happened caused of GPS antenna cannot received a signal from satellite.

The principle of GPS state that the GPS typically will not works indoor, underwater or underground. There is no signal if the GPS was located in a building and so on.

This case absolutely relate with GPS standard. To make sure a measurement of GPS, the open areas are needed in order to get an accurate of GPS data.

ARDUINO GPS CONFIGURATION PART II

GPS Screen for Latitude and Longitude location.

The function of GPS Shield for Arduino used to produce a GPS data, to store the data through SD card and find out the location detected. Futhermore, The Arduino Uno will support the features of GPS Shield in order to pointed out the result of the project.

The GPS Screen configuration are here:

The conclusion that I can made from this GPS configuration is FAILED current to the technical problem. The result is showed above where is no detection of location and trying to get real data.

I will re-test and re-trying for the next solution to find the current location detection.

ARDUINO GPS CONFIGURATION

Here the progress that I've done until week 4. Not to many that can be shared on this blog because of my focus still on the GPS configuration. Basically, I need to learn more about Arduino GPS and data longer output.

My schedule is try to find out with a good solution for the errors occurs. This solution to make sure my project can run smoothly.